Drivetrain

Weight (lbs): 3.52 Safely install a new bearing using hand tools Job can be performed with the transmission still in the frame Holds bearing square to its bore, eliminating any marring of the bearing bore Jims Main Bearing Installer Tool For use on Dyna...

Weight (lbs): 3.68 Stabilizer has a forged steel construction with precision rod end bearings. Motor-swingarm assembly remains aligned with chassis, without any unnecessary vibrations. Easy to install stabilizer does not change ground clearance...

Weight (lbs): 1.98 "ANDREWS" Mainshaft. 1965-1969. Length 11.985". By: ANDREWS PRODUCTS INC

Weight (lbs): 3.09 These 8mm, 47 tooth engine pulleys are direct replacement parts for Belt Drives Limited (BDL) primary belt drive kits All pulleys are hard anodized aluminum with cast-in steel inserts to maximize the lifespan and provide the greatest...

Weight (lbs): 4.82 Made for the longer valve and spring combination of the Evolution but will still work on all early Big Twin and Ironhead Sportster models Jims Black Wrinkle Powder Coated Works on all Big Twin & Sportster heads, all years Replaces HD#...

Weight (lbs): 2.95 Used to install Timken ® style main bearing onto sprocket shaft Includes a sandwich bearing that provides a smooth installation process Requires tool 60762 to install Timken ® bearing or roller bearing inner race on 2006-Later 6 speed...

Weight (lbs): 1.71 These mainshafts represent the finest available in both imported and American made Andrews. All are manufactured to the highest specifications. "ANDREWS" All Models 1971-Early 1984. By: ANDREWS PRODUCTS INC

Weight (lbs): 1.84 The 14mm by 3 3-8" belt is the same that the top fuel racers use on their 600 plus horsepower machines. This kit is designed for oil filter (included) mounting in the motor plate. Kit is the complete drive with outboard bearing...

Weight (lbs): 3.10 Use to remove the larger 2 1 - 4 " hex nut from the end of main drive gear, which secures the rear drive trans pulley. Very safe and easy to use. Just thread on the inner support collar to end of mainshaft, place the socket over the...

Weight (lbs): 0.00 Incorrect piston pin clip removal can damage the piston and incorrect installation can damage the clip. Damaged clips can come out during engine operation causing catastrophic failure. This tool is designed exclusively for the...

Weight (lbs): 2.64 For all length Big Twin transmission mainshafts so that you can properly torque the sprocket-pulley nut to 100-120 ft.-lbs. For use with 1 - 2 " drive ratchet, impact or torque wrench Left hand threaded collar Screws Pack of 10 on end...

Weight (lbs): 2.11 Ever try to remove a cam bearing from a Big Twin gear case without splitting the case and have a needle bearing roller fall into the cases? That will never happen with this high quality tool. The cam gear needle bearing must be...