Engine

Weight (lbs): 3.52 Safely install a new bearing using hand tools Job can be performed with the transmission still in the frame Holds bearing square to its bore, eliminating any marring of the bearing bore Jims Main Bearing Installer Tool For use on Dyna...

Weight (lbs): 0.00 Bolt-in cams for more performance for your Milwaukee-Eight® powered motorcycle. Adjustable pushrods and performance lifters also available. Andrews® Cam for bigger cubic inches.  More torque and power for modified engines (1600-5500...

Weight (lbs): 1.85 Eliminates flex Decreases engine temperature Increases oil flow Use with Oil Pump 67089 for maximum efficiency Includes bearing retainer plate and hardware Use with gear drive cams only, unless using 67601 with 66701 V-FACTOR Fits:...

Weight (lbs): 8.62 Cylinders can be used for front or rear applications Includes cylinder stud inserts for head alignment Sold Each Note: Not intended for high performance applications V-FACTOR Black Wrinkle Finish Fits: Harley Big Twin Evolution...

Weight (lbs): 4.48 These Connecting Rod Assemblies include rods, single hole crank pin, crank pin nuts, piston bushings & rod rollers with aluminum retainers. Everything is fitted with standard size rollers ready to install. All rod sets measure 7.438"...

Weight (lbs): 0.95 By using a bolt cutter to remove your OE pushrods, these can easily be installed without removing your fuel tank or rocker covers These are a real time saver when installing performance cams Installation instructions are included...

Weight (lbs): 1.02 Install these pushrods easily without removing your fuel tank or rocker covers A must when installing a performance cam See below for availability of finish and strength Andrews Ultimate Strength Chrome-Moly Pushrod Set Fits: Harley...

Weight (lbs): 2.28 Use with cams up to .600" lift with this kit Includes race master stainless steel valves Steel top valve spring collars Valves are OE style triple keeper grooves Does not require cylinder head machining Springs are single conical ovate...

Weight (lbs): 4.82 Made for the longer valve and spring combination of the Evolution but will still work on all early Big Twin and Ironhead Sportster models Jims Black Wrinkle Powder Coated Works on all Big Twin & Sportster heads, all years Replaces HD#...

Weight (lbs): 2.50 465C chain drive and 465G gear drive cams both provide increased torque and horsepower kits include all required bearings, O-rings, and hardware Gear drive cams provide improved valve timing accuracy Made in the USA 550C Chain drive...

Weight (lbs): 1.92 508 Cam - Bolt-in cam intended for stock engines with less than 10:1 compression ratio. Quiet valve train with excellent low to mid-range torque for touring and 2-up riding 510V Cam - Bolt-in cam that works well with stock or ported...

Weight (lbs): 2.95 Used to install Timken ® style main bearing onto sprocket shaft Includes a sandwich bearing that provides a smooth installation process Requires tool 60762 to install Timken ® bearing or roller bearing inner race on 2006-Later 6 speed...